New outdoor meter and panel enclosure at the end of the project

Electrical panel upgrade

A 200-amp panel upgrade with underground service

Menderix replaced the outdoor electrical panel and the underground service conductors that feed it. The new 200-amp cabinet went on the exterior wall. The trench ran through the narrow space between the house and the fence.

Service rating: 200 ampsPanel location: Exterior wallService route: Underground
Original outdoor panel with the cover raised and the meter removed
Original cabinet with the meter removed.
Completed 200-amp outdoor panel with its hinged breaker door open
Replacement cabinet with the breaker door open.

Inside the old and new meter cabinets

In the old enclosure, the round meter socket sat below the breakers. In the replacement cabinet, the meter sits on the left, with a separate door for the labeled breakers on the right. The homeowner can reach the breaker handles while the wiring stays behind its cover.

Replacing the cabinet took care of the equipment on the wall. To replace the conductors feeding it, our crew also needed access to the stretch of yard along the fence.

The open trench turns along the wall, between the house and fence.

A narrow side yard shaped the service route

The trench follows the wall, then bends near the building. The fence leaves little space to work on either side of that turn. For a job like this, we need to see the whole route when we estimate the trench work.

When you compare panel upgrade quotes, check where each one starts and ends. One may cover just the meter and breaker equipment at the house. If the service conductors also need replacing, ask who will open the trench and restore the surface afterward.

A tape measure beside exposed conduit at the bottom of the trench
Conduit at the bottom of the trench, with a tape measure alongside it.

Getting an estimate for an underground service upgrade

Start with access. Is the strip beside the house open soil, concrete, a planted bed or a walkway the household uses every day? A wide photo from each end can be more useful for estimating the work than another close-up of the meter.

Tell us what you plan to run on the new service. A heat pump, an EV charger or new workshop equipment could change the size you need. If you’re replacing a worn cabinet and plan to keep the same equipment, we can check whether your current service still meets your needs.

Have a panel or underground service to replace?

Send a photo of the closed panel and a view of the available route. Tell us what equipment you plan to add and which parts of the yard you need to keep accessible.